Building a new plate holder

Arturo · Post by **Arturo** » Tue Jan 18, 2011 2:45 pm

holomaker wrote:heres a jig i use with for one beams........

I love this one! It has the simplicity and gravity stability based on three points, but allows fitting dificult geometry objects!

holomaker · Post by **holomaker** » Wed Jan 19, 2011 10:40 am

yes its vary adaptable! when doing proximity transfers as well , i simply lay master down first and adjust height for the depth of the h2 and its ready too shoot. The object in that picture is actually upside-down! The shadow would be very bad positioned like that! To get perfect registration i have two support rods with 90 degree notches in the ends to capture the two corners of the plate. Thusly allowing you to remove and replace your film plate and maintain proper registration ..........