Flow rate in pipes

These are all of the old posts from the first two years of the forum. They are locked.
Updated: 2005-03-28 by HoloM (the god)
Locked
Colin Kaminski

Flow rate in pipes

Post by Colin Kaminski »

John,

I found this today and thought I would post it for you. I think you already solved your flow problem but here it is:

http://www.thermexcel.com/english/ressourc/pdcline.htm


JohnFP

Flow rate in pipes

Post by JohnFP »

Yes I did, thank you. I ran the water backwards through the laser and power supply and all is well. It seems there may have been a small restriction in the laser or power supply that required a higher water pressure for the correct flow rate. Now the pressure is regulated and all is well. Thanks again.
Locked