Holographyforum.org / holowiki.org

Custom 300mw Coherent Sapphire 532 laser system complete. Ready to ship, tested for SLM, a perfect laser to use for DCG and photopolymer…
$750 w USA shipping and 90 day warranty , out of country shipping will be paid by buyer..

This laser will require a heat sink

Joe, I’m not sure if you mentioned what laser you were using as I read through. But I find the PL 530 laser has a hotspot more so than other lasers do. What that means if you need to throw more light away on the edges and use that central version like you had to with, other typical Diode Lasers , in...

Can’t use thin glass as a splitter, needs to be thicker as the outputs need to be separated more, sounds like there are too close to each other ( like stepping on each other) causing interference bands… try a1/4” plate..

Yes

Mr wizard, Not so sure about that ! Some high power gas lasers liked to run nice and constant, w this tool the output could be finely adjusted without touching any parameters on the laser…?

Are you sure the glass is tempered, I’ve broke a few of these and by the way the glass brakes I’ll say “it’s not tempered?”. If this is true pre cut phone glass, apply and easily grind the thin edges?

Looks promising Danny, is this the new batch of Bayfol ?

Remember these green lasers were in production for only a short period of time, and then quickly replaced w direct (easy to modulate) green diodes ....

One of the reasons for all the technology in the 530, was so it could be modulated quicker than conventional DPSS configuration. As of Now I’ve not tested for SLM while modulated, the initial IR output at the diode is quite narrow frequency to begin ..(distributing feedback Laser using a Holographic...

Mr Astro wrote: ↑Fri Sep 11, 2020 8:30 pm thanks for the laser
here is my test
little old lady.jpg

Can you provide a couple more pictures/information ? Nice work